This modifies `bar_cmd_tray_bindsym` to use `get_mouse_bindsym` for
parsing mouse buttons. This also introduces `bar_cmd_tray_bindcode`,
which will use `get_mouse_bindcode` for parsing mouse buttons. Like with
sway bindings, the two commands are encapsulated in a single file to
maximize shared code.
This also modifies tray bindings to work off of events codes rather than
x11 buttons, which allows for any mouse buttons to be used.
For `get_bar_config`, `event_code` has been added to the `tray_bindings`
section and will include to event code for the button. If the event code
can be mapped to a x11 button, `input_code` will still be the x11 button
number. Otherwise, `input_code` will be `0`.
This modifies `bar_cmd_bindsym` to use `get_mouse_bindsym` for parsing
mouse buttons. This also introduces `cmd_bar_bindcode`, which will use
`get_mouse_bindcode` for parsing mouse buttons. Like sway bindings, the
two commands are encapsulated in a single file with shared code.
This also modifies swaybar to operate off of event codes rather than x11
button numbers, which allows for any mouse button to be used.
This introduces two new IPC properties:
- For `get_bar_config`, `event_code` has been added to the `bindings`
section and will include to event code for the button. If the event code
can be mapped to a x11 button, `input_code` will still be the x11 button
number. Otherwise, `input_code` will be `0`.
- Likewise for `click_events`, `event` has been added and will include
the event code for the button clicked. If the event code can be mapped
to a x11 button, `button` will still be the x11 button number.
Otherwise, `button` will be `0`.
If the tokener parses incomplete json, it sets its error value to
json_tokener_continue. This means that extra json should be provided,
but the code was providing the entire object again. In the interest of
simplicity, the tokener is reset so that buffer_pos always points to the
start of the current object.
This now correctly handles an incoming json infinite array by shifting
most of the heavy listing to the json-c parser, as well as sending
multiple statuses at once. It also removes the struct
i3bar_protocol_state and moves its members into the status_line struct,
allowing the same buffer to be used for both protocols.
This prevents blocks from being destroyed before their hotspots are destroyed,
in case it is used for a pending click event that fires between the bar
receiving a new status, which destroys the block, and the bar rendering the new
status, which destroys the hotspot; this problem can be easily produced by
scrolling on a block that immediately causes a new status to be sent, with
multiple outputs
As well as ignoring scroll events on status elements when click_events
is enabled.
Previously, using the scroll wheel on a workspace button would switch to
that workspace instead of scrolling through them. Clicks and scrolling
on status elements would always be processed by swaybar, too. So in case
you were using scrolling as volume control on a status item, swaybar
would additionally scroll through your workspaces.
